Copyright SMART Technologies.All Rights Reserved.Header

The Image Doesn’t Fill Your SMART Table’s Display

Issue

The image doesn’t fill your SMART Table interactive learning centre’s display, or the image is off centre.

Symptoms

A dark band appears across the top, bottom or side of your SMART Table interactive learning centre’s display.

Cause

A mirror or the projector inside your SMART Table interactive learning centre isn’t aligned properly.

Solution

If the dark band appears at the top or bottom of the display, adjust the lower mirror inside of your SMART Table interactive learning centre.

OR

If the dark band appears on the side of the display, adjust the projector position.

To adjust the lower mirror

1. Remove the side panel on the opposite side of the SMART Table interactive learning centre’s USB connection.

2. Adjust the angle of the lower mirror upward until the image fills the display.

   Note 

   You may have to loosen the side screws that hold the mirror in place.

   

3. Tighten the screws and then replace the side panel of the cabinet.

To adjust the projector

1. Remove both side panels of the SMART Table interactive learning centre cabinet.

2. Loosen the four allen screws that hold the projector mounting plate in place.

3. Adjust the alignment of the projector from left to right until the image is centred on your SMART Table interactive learning centre’s display.

   

4. Tighten the screws and then replace the side panels of the cabinet.

Copyright SMART Technologies.All Rights Reserved.Footer